Using those is meant to overcome for things which are (still) not possible with. Net. Take a look at system. I don't know if opening and closing of a disc tray is possible with that, but it can be that the feature is removed, because the OS does that if there is needed to load a new disc or a disc is burned. But with batch I know how to. So please don't flame me if I am not getting everything right. I joined this forum to learn how to code. VB. And I am trying to do as many different projects as possible.@kaymaf. I tried what you suggested but it throws this error still. PInvoke. Stack. Imbalance was detected. Message: A call to PInvoke function 'Windows. Application. 1! Windows. Application. 1. Form. Send. String' has unbalanced the stack. This is likely because the managed PInvoke signature does not match the unmanaged target signature. Check that the calling convention. PInvoke signature match the target unmanaged signature. This is my source so far. Public Class Form. Declare Function mci. Send. String Lib.
HP Desktop PCs - Opening a Stuck CD or DVD Drive Tray (Windows 7, Vista, XP)In Windows 7 or Windows Vista, click Start , and then click Computer. In earlier versions of Windows, click Start, and then click My Computer. Right- click the icon for the disc drive that is stuck, and then click Eject. Figure : Eject disc in Windows 7 Wait about 3 seconds and then try closing the drive tray by pressing in on the front of the tray. If the drive tray resists and stays open, continue using these steps. Use Microsoft System Restore to go back to a time when the drive tray was operating normally. Open Cd Tray Program TelewizyjnyThe media tray pops open. Insert a CD in the tray and press gently on the disc so the center hole snaps onto the spindle in the center of the tray. Push the tray straight into the laptop to close. Open or Close a CD/DVD Drive Drawer. Open and Close CD/DVD Drive Tray. An Introduction to Application Performance Management (APM) Open and Close CD/DVD Drive Tray. Open Cd Tray Program MaIf the drive tray closes normally after using system restore, no further action is necessary. Otherwise, continue using these steps to reset the drive tray state. Turn off the computer and disconnect the power cord. Remove the side panel. Disconnect the cables from the back of the disc drive and set the loose ends of the cables away from any fans. If the drive is a SATA drive, make sure to squeeze the connectors when removing them to avoid breaking the clasps. Figure : Cables on disc drive. Reconnect the power cord and turn on the computer. Wait until Windows fully loads and then restart the computer. After Windows fully loads (again), shut down the computer and disconnect the power cord. Reconnect the drive cables. Replace the side panel. Connect the power cord and turn on the computer. The Eject feature should work properly.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2016
Categories |